BatteryMINDer 24041-AA-S1 - Manual (Page 21)

Rev. F-103007 P/N VDC24041AA-S1-MNL
BatteryMINDer ® Model 24041-AA-S1
Page 21
INSTRUCTIONS:
TEMPERATURE SENSOR Type: ABS-124
(At-the-Battery Sensor)
MANDATORY WHEN CHARGER IS USED WITH
Sealed or Maintenance-type Aviation batteries,
regardless of construction (Gel, AGM, Free-
Electrolyte = filler caps)
Congratulations on purchasing the most advanced
charger-maintainer-desulfator conditioner on the
market today. Read you manual carefully to under-
stand all of its features. Your charger came with the
At-the-Battery Sensor ABS-124. Please read and
fully understand all of the following before beginning
your installation.
Your temperature sensing system is made up of
two components. The thermal sensor w/ ring ter-
minal and male plug w/ dust cover both shown
below with extension cord attached. This cord then
attaches directly to the mating female receptacle
located on the charger
Do NOT modify by extending or shortening the
extension cord.
Attaching the temperature sensor with extension
cord.
Your first choice should be to connect it to the
Positive (+) or Negative (-) post (clamp / screw) of
the battery. This is the best location to sense the
temperature of the battery.
The second choice is to place it as close to the
battery as possible. Attachment of the sensor to
the side or top of battery is also a possible option,
under the right circumstances. Be careful to ensure
it will not come loose in service.