Autel MaxiTPMS TS501 User Manual
Page 23
22
One Wheel Mode
In this mode the screen will show as below (Figure 4.10). The tool will
check TPMS sensor on the single wheel. Place the tool alongside the
valve stem, point toward the sensor location, and press the TEST
button. Wait for test result before moving the tool.
Figure 4.10
The tool will send LF signal to trigger the sensor. Depending on the
sensor type, the tool will activate the sensor on the first or last step.
Once the sensor is successfully activated and decoded, the tool will
display as below with a beep. (Figure 4.11)
Figure 4.11
Once the first sensor test is completed, the screen will hold for 3
seconds for data viewing and then switch to next sensor test. Follow
the same procedure for the other sensor tests.
The tool can save up to 5 TPMS sensor data records at each time. Press
the UP/DOWN or LEFT/RIGHT scroll button to turn over data
screens while viewing. If more than five records are stored, the latest
record will overwrite the first one.