Atec Tektronix-VITS100 - Manual (Page 2)

VITS 100 NTSC VITS Inserter Instruction Manual 3–1
Specifications
This section contains tables that list the specifications for the VITS 100 NTSC
VITS Inserter. All specifications are guaranteed unless noted “typical.”
The performance limits in this specification are valid with these conditions:
H The VITS inserter must have been calibrated/adjusted at an ambient
temperature between +20 _ C and +30 _ C.
H The VITS inserter must be in an environment with temperature, altitude,
humidity, and vibration within the operating limits described in these
specifications.
H The VITS inserter must have had a warm-up period of at least 20 minutes.
Specification Tables
Table 3–1: Program channel characteristics
Characteristic Information
Gain Unity
±
1%
Frequency Response
±
1% to 5.5 MHz
±
3% to 10 MHz
Chrominance-to-Luminance Gain
±
0.5%
Chrominance-to-Luminance Delay
≤
5 ns
Diff Phase
≤
0.2
°
Diff Gain
≤
0.2%
Line Tilt
≤
0.5%
DC Output Level 0 V
±
10 mV
DC Matching of Inserted Test Signal to
Program Signal
±
3 mV
Phase Match (Relay Bypass Path to Signal
Processing Path)
±
1
°
at F
SC
Hum Rejection 50 dB (Measured right after burst)
Keyboard (No Noise) Too small to measure on VM700A
Insertion Transients
≤
10 mV (Measured on Tektronix 1780R. Typically <5 mV)
Input Impedance 75
W
Return Loss 36 dB to 5 MHz (Program In, Program Out, and Monitor Out)