Atec Tektronix-WVR500 - Manual (Page 10)

Specifications
WVR500 Waveform/Vector Monitor Service Manual 1–9
Table 1–9: Certifications and compliances
Category Description
EC Declaration of Conformity Compliance was demonstrated to the following specifications as listed in the Official
Journal of the European Communities:
EMC Directive 89/336/EEC:
EN 50081-1 (Emissions):
EN 55022 Class B Radiated and Conducted Emissions
EN 50082-1 (Immunity):
IEC 801-2 Electrostatic Discharge Immunity
IEC 801-3 RF Electromagnetic Field Immunity
IEC 801-4 Electrical Fast Transient/Burst Immunity
Conditional Statements:
1. High quality shielded cables must be used to insure compliance to the
above listed standards.
Low Voltage Directive 73/23/EEC, Amended by 93/68/EEC:
EN 61010-1 Safety requirements for electrical equipment for measurement,
control, and laboratory use. Part 1: General Requirements.
Safety Standards
U.S. Nationally Recognized
Laboratory Listing UL1244 Standard for Electrical and Electronic Measuring and Testing Equipment.
Canadian Certification CAN/CSA C22.2 No. 231 CSA Safety Requirements for Electrical and Electronic
Measuring and Test Equipment.
European Union Compliance Low Voltage Directive 73/23/EEC, Amended by 93/68/EEC.
EN61010-1 Safety Requirements for Electrical Equipment for Measurement, Control, and
Laboratory Use.
Additional Compliance IEC1010-1 Safety Requirements for Electrical for Measurement, Control, and
Laboratory Use.
Safety Certification Compliance
Temperature, operating +5 to +40 _ C
Altitude (maximum operating) 2000 meters
Equipment Type Test and measuring
Safety Class Class I (as defined in IEC 1010–1, Annex H) – grounded product
Overvoltage Category Overvoltage Category II (as defined in IEC 1010–1, Annex J).
Pollution Degree Pollution Degree 2 (as defined in IEC 1010–1). Note: rated for indoor use only.