Atec Frankonia-MTS-800 - Manual (Page 4)

Magnetic-Field Test System / Low-Frequency Test System
for Emission and Immunity Tests / MTS-800
Technical specifications
Voltage input (Analyzer)
Frequency range DC - 250 kHz
Input impedance 1 M Ω / 50 Ω switchable
Connector XLR, unbalanced
Max. input voltage 100 V continuous (attenuator autoset at overvoltage); 10 V at 50 Ω
Gain -20/0/20 dB Preamplifier, 0/20/40 dB ADC Amplifier; Self-calibration with ultra stable on-board reference
Current input
Frequency range DC - 250 kHz
Shunts 10 m Ω / 1 Ω / 100 Ω
Max. input current 20 A continuous (overload protection); 1 Ω and 100 Ω shunt are protected by an additional 1.5 A fuse
Connector 4 mm safety jack (+, -) measurement via insulation amplifier or input jacks
Measurement range 20 A, 10 A, 1 A, 100 mA, 10 mA, 1 mA automatic offset and gain;
Self-calibration with ultra stable on-board reference
AD converter
Resolution 16 Bit
Sampling rate 1.25 MSPS
Aliasingfilter 0.01 dB Tschebyscheff filter, fg = 260 kHz; filter may be switched off
Generator
Frequency range DC - 250 kHz
Output impedance 50 Ω
Connector BNC, unbalanced
Signal Sine wave / triangular /square wave/ DC
Amplitude 0 to 10 VAC, -10 V to +10 VDC
Resolution 12 Bit (2.5 mV), Switchable - 20 dB Attenuator; Self-calibration with ultra stable on-board reference
Amplifier
Frequency range DC - 1 MHz
Connector 4 mm safety jacks (output); BNC, unbalanced (input)
Current 16 Arms
Voltage 50 Vrms / 75 VDC
Distortion (DC-100 kHz, load ≥ 4 Ω ) < 0.10 %
General data
EUT control / Connector 9-pin Sub-D; RS232
Connection to Computer USB
Temperature range 0 to 40 °C
Warm-up time 15 min.
Housing 19”-Subrack or desktop case
Dimensions (W x H x D) 449 x 177 x 580 mm
Weight (shipping) approx. 40 kg (net 34 kg)
Gain 10 ± 0.1 % (±0.01 % / °C) PAGE // 24