Atec Frankonia-MTS-800 - Manual (Page 2)

Magnetic Field Generation
MTS-800 enables a user to generate strong magnetic fields
up to 1000 A/m. Even alternating fields up to 250 kHz can
be generated by the magnetic test system.
Automotive Testing
Intensive testing is required for new products which should
be used in any automotive application. The MTS-800 al-
lows fast and easy testing according to many automotive
standards as described before.
Components
MTS-800 consists of three independent module: a signal genera-
tor (DC – 250 kHz), a power amplifier (800 W output maximum,
DC – 1MHz bandwidth) and spectrum analyzer (16 Bit, 1 MSPS
sampling rate). All modules can be used as stand-alone units.
Automatic Testing Capabilities
Full compliance with several immunity test as
ISO 11452-8, MIL-STD-461E/F RS101, CS101, CS109,
IEC/EN 55103-2, IEC/EN 61000-4-8, SAE J1113-2,
SAE J1113-22, Ford ES-XW7T-1A278-AC, GM W3097,
PSA B21 7110, Renault 36-00-808, DC-11224,
DC 10614 and similar standards.
Furthermore the MTS-800 allows emission measurements ac-
cording to MIL-STD-461E/F RE101, CE101 and IEC/EN 55103-1.
Software
Any function is controlled via an application software which
also guide the user through any test or measurement. Ad-
aptation of signal strength or measurement graphs are pos-
sible at any stage. User defined signals complement the
usage for fast and reliable tests. The application software
is written in LabVIEW which guarantees stable and fast per-
formance on any Microsoft® Windows platform.
Accessories
Frankonia provides also many different coils and loop sensor which
are ideally suited for the described tests. Any additional equipment
is ready to use without a need for recalibration. Not only our own
equipment can be used with the MTS-800, but also user defined
coils. A calibration mode is included in the software to complement
the magnetic test system with any further equipment.
Self-calibration
Using an ultra-stable voltage source self-calibration correction
values are stored in an internal EEPROM. Any voltage signal or
voltage measurement device is calibrated at a self-calibration
process automatically in about a minute.
Low Frequency emission and immunity tests
acc. to MIL-STD 461E, CE 101, RE 101, CS 101, CS 109 and RS 101.
Individual software modules and hardware accessories are avail-
able for each of these tests.
Applications:
Features:
Magnetic-Field Test System / Low-Frequency Test System
for Emission and Immunity Tests / MTS-800
PAGE // 22