Atec Frankonia-MTS-800 - Manual (Page 3)

The software starts with the generator/amplifier control panel.
This window allows basic settings of generator and amplifier.
Control Panel
Open the Magnetic field measurement window for spectrum
analyzer measurements. Perform a single or continuous mea-
surement. Perform test according to predefined standards.
Measurement results
Edit a predefined standard or create a new one.
Load, save and print data.
Example standard file for MIL-STD-461E / RS101_Navy
Open the Magnetic field generation window for suscep-
tibility tests according to predefined standards.
Standard generation window
Open the continuous generation window for long term
magnetic field test.
Magnetic field continuous generation window
Magnetic-Field Test System / Low-Frequency Test System
for Emission and Immunity Tests / MTS-800
Further features and possibilities:
Susceptibility tests with fixed frequencies and test levels or
use the ramp function to sweep from start to stop level. Verify
the generated field of any radiating coil with loop sensor.
Short term generation window for short term magnetic field
tests (optional).
Scope mode window.
Determine the coil factor of an unknown coil
Self calibration of the MTS-800
23 // PAGE