Atec Panametrics-35DL - Manual (Page 2)

Cylinder bores and many other cast metal parts or
sound-attenuating materials can be measured with
the 35HP gages. Measure depth to steel / ply cords in rubber conveyor
belts or tires. The 35HP gages are excellent tools to measure fiber-
glass or composite parts, from aerospace structures
to boat hulls and storage tanks that require thickness
control.
With a very low ultrasonic frequency bandwidth and a special
pulser-receiver, the HP gages are specifically designed to optimize
ultrasound penetration when measuring thick, highly sound attenuat-
ing or sound scattering materials. Typically these materials cannot be
measured with most other ultrasonic thickness gages.
35HP and 35DL-HP
Models 35HP and 35DL-HP are used
in sound-attenuating materials
To thick materials ...
Why HP gages?
For more than three decades, Panametrics-
NDT thickness gage engineers have developed
the HP (High Penetration) series specifically
for very sound-attenuating or thick materials.
Not only can these gages use transducers as
low as 0.5 MHz but their electronics (pulser-
receiver) are highly optimized to process
signals at these low frequencies. The result
is that the Panametrics-NDT gages have
earned a reputation for superior performance
in measuring thick rubber, fiberglass,
composites, and other tough materials.
- most thick or sound-attenuating
materials
- thick cast metal parts
- thick rubber tires, belts
- fiberglass boat hulls, storage tanks
- composite panels
- resolution of 0.01 mm or 0.001”
applications