Atec Rohde-Schwarz-ESPI_Series_DatasheetsЙ - Manual (Page 10)

10 Test Receiver ¸ESPI
Optional tracking generator
9 kHz to 3 GHz
The optional Internal Tracking Generator
¸FSP-B9 up to 3 GHz and External
Generator Control ¸FSP-B10
enhance the two ¸ESPI test receiver
models to yield scalar network analyzer
functionality. Gain, frequency response,
insertion and return loss are measured
using a selective method with a wide
dynamic range without being affected by
harmonics or spurious from the genera-
tor. The Internal Tracking Generator
¸FSP-B9 can be used in both
¸ESPI models and covers the fre-
quency range from 9 kHz to 3 GHz. A fre-
quency offset of ±150 MHz can be set for
measurements on frequency-converting
modules. The tracking generator can be
broadband-modulated by an external I/Q
baseband signal.
Optional LAN interface
With the aid of the optional LAN Interface
¸ FSP-B16, the ¸ESPI models can
be connected to common networks such
as 100Base T so that functions such as
file logging on network drives or docu-
mentation of measurement results via
network printer are available. The
¸ESPI can also be remote-controlled
via the LAN interface. Control is via a soft-
panel that behaves exactly as if it were
part of a real instrument. The LAN inter-
face has a clear speed advantage over
the IEC/IEEE bus – in particular when
large blocks of data are transmitted.
Easy generation of reports
owing to PC compatibility
◆ PC-compatible screenshots, no
conversion software being required
◆ Windows printer support
◆ LabWindows driver
◆ LabView driver
◆
SCPI-compatible
◆
¸FSE/ESIB-compatible GPIB
command set
◆
Customized training
Rear view with interfaces for tracking generator with I/O, LAN and user port