Atec Megger-ODEN-AT - Manual (Page 6)

ODEN AT
Primary Current Injection Test System
Optional accessories
Multi-cable high current cable sets
Low-impedance multi-cable sets for higher output current.
Available with 2, 3, 4 or 6 parallel cables, and in lengths of 0.5,
1.0, 1.5 or 2 meters.
Cable sets
See Ordering Information.
Current transformer switchbox
The Current Transformer (CT) Switchbox for ODEN AT is
a tool that is used to facilitate CT testing. The secondary wind-
ings on the CT are connected to the CT Switchbox inputs and
the CT Switchbox output is connected to ODEN AT Ammeter
2 terminals. The switch on the CT Switchbox is used to select
which secondary winding on the CT that should be measured.
The windings that aren’t measured are short-circuited. The CT
Switchbox can handle up to 5 secondary windings.
High current serial bar
For serial connecting of ODEN current units.
HCP2000 — High Current Probe
The high current probe, HCP2000, is a tool that makes it
possible to test Molded Case Circuit Breakers (MCCB), without
removing/uninstalling the circuit breaker. The high current
probe operates up to 2000 A trip current.
Input power adapter 240/400V
Used to run a 400 V ODEN AT at 240 V.
High current parallel bars
The parallel bars can be used when up to three current units
are connected in parallel.