Atec Agilent-N5264A - Manual (Page 8)

Data Transfer Time (ms)
Description Typical Performance
Number of Points
201 401 1601 16,001
SCPI over GPIB
Program executed on external PC
5
32-bit floating point
5.6 10.5 39.9 400
64-bit floating point
10.5 20.3 79.2 788
ASCII
46 92.5 370 3702
SCPI over SICL/LAN or TCP/IP Socket
Program executed in the analyzer
32-bit floating point
0.18 0.21 0.5 3.6
64-bit floating point
0.22 0.28 0.62 5.3
ASCII
6.3 12.3 47.3 470
COM 6
Program executed in the analyzer
32-bit floating point
<0.15 0.15 0.2 0.7
Variant type
0.75 1.2 4.5 50
DCOM over LAN 6
Program executed on external PC
32-bit floating point
<1.0 1.2 2.1 13
Variant type
2.7 4.5 15 150
1
Includes sweep time, retrace time and band-crossing time. Analyzer display turned on. Minus
21 ms from total time for display off with DISPLAY:ENABLE OFF. Data for two traces (A & B
receiver) per measurement.
2
After first complete sweep.
3
When configuring the N5264A Option 108 as the LO source, you may improve system
measurement sensitivity by using a method of AM noise suppression.
4
Performance Characteristics when connected with 85309A and 85320A/B mixers - system
noise floor + conversion gain.
5
Measured when using the SCPI command DISPlay: VISible OFF.
6
Values are for real and imaginary pairs, with the analyzer display off.