Atec Agilent-N5264A - Manual (Page 13)

Trigger Information (Cont.)
Description Typical Performance
Trigger out/Meas Trigger Ready
Nominal Input Impedance
5K Ohm
Pulse Width
= Data acquisition
Polarity
Selectable with sweep or point mode
Drive Voltage
TTL (0, +5.0) Volts
Trigger Inputs/Outputs (Aux. 1 & 2)
BNC(f), TTL/CMOS compatible
GPIB (two ports - dedicated controller and
dedicated talker/listener)
24-pin D-sub (Type D-24), female; compatible with
IEEE-488.
Parallel Port (LPT1)
25-pin D-Sub miniature connector, female; provides
connection to printers or any other parallel port
peripherals
Serial Port (COM 1)
9-pin D-Sub, male; compatible with RS-232
USB Port
Four ports on front panel (all Host) and five ports
(four hosts and one Device) on rear panel. Type A
configuration (eight hosts) and Type B configuration
(one Device), USB 2.0 compatible.
LAN
10/100BaseT Ethernet, 8-pin configuration; auto
selects between the two data rates
Line Power
Description Typical Performance
Power supply is auto switching
Frequency, Voltage
50/60 Hz for 100 240 VAC
Max
450 watts
1
Measurement conditions: normalized to -10 dBm, 10 Hz IFBW, averaging factor of 8.
2
Absolute LO frequency is Front Panel set frequency plus 1 IF.
3
No band crossings; IFBW ≥ 100 kHz with 801 measurement points.
4
Listed frequency is the harmonic frequency setting entered with front panel (frequency
setting entered with front panel plus {IF frequency} * {harmonic number}) at typical power.