Atec Espec-TSE-11-A - Manual (Page 9)

8
■Some photographs listed in this catalog contain Japanese display.
Auxiliary cooling injector (LCO
2
)
Used to reduce the temperature
recovery time of low temperature
exposure by injecting liquef ied
carbon dioxide at the beginning of
exposure.
Auxiliary cooling injector (LN
2
)
Used to reduce the temperature
recovery time of low temperature
exposure by injecting liquef ied
n i t r o g e n a t t h e b e g i n n i n g of
exposure.
Cable port rubber plug
Prevents air leakage from the cable
port.
Specimen basket
Equivalent to standard accessory.
・Material: stainless steel (5 mesh)
Anchoring fixtures
Used to bolt the chamber to the floor.
Power cable
Used to connect to the primar y
power source.
・5m
・10m
Color specification
Chamber can be painted to any
desired color. (a color sample is
required)
Additional overheat protector
Additional preventive measures can
be taken for excessive temperature
rise in the chamber, in addition to
the standard equipped overheat
protectors.
External alarm terminal
If the safety device of the chamber
is activated, the exter nal alar m
terminal will notify it to a remote
point.
Emergency stop pushbutton
Stops the chamber immediately.
Total cycle counter
Indicates cycle counts.
Display range: 1 to 99999999
(with reset function)
Thermocouple
Attached to specimens to measure
specimen temperature.
・2m
・4m
・6m
* T JIS C 1602 with ball attached
Interface
Communication cable
・Computer interface GPIB
・Serial interface
RS−232C
*Select one, instead of standard RS−485.
・RS−485 5m/ 10m/ 30m
・GPIB 2m/ 4m
・RS−232C 1.5m/ 3m/ 6m
To output temperature values from
the test area, hot chamber, cold
chamber.
Terminal for recorder
OPTIONS
External alarm
terminal (option)
Specimen
power supply
control
terminal
Time signal