Associated Equipment 12-1015 Quick Guide - Manual (Page 6)

6
26. Press key to continue and the display
will show as follows:
27. Switch the ignition key to ON and start
cranking the engine until it starts. Immediately
after that press key and the results will
show as follows
:
28. If the voltage drop is too great during the
cranking, the tested results will display as
follows and will prompt you to check the
starter system.
29. During cranking when it detects that there is
no drop in voltage, it will display the following
screen:
30. To exit the program, pressing the
key at any moment will exit and return back
to the main menu screen.
Alternator Test
No load testing at 3000 RPM:
31. With engine OFF, place the vehicle
transmission in NEUTRAL for Manual and
PARK for Automatic and apply the parking
brake.
32. Pressing key once will scroll down to the
“Alternator Test”
Starter Test
Battery: 12.45V
Crank engine now
until it starts. Then
press [Enter].
Result: OK
Min. Volts: 10.56V
Volt Drop: Normal
Press [Exit] to main
menu.
Result: High Drop
Min. Volts: 8.56V
Volt Drop: High
Check starter relay,
battery terminals or
battery has aged.
Press [Exit] to main
menu.
Result: Not detected
No change in volt drop.
Check clamping at
battery side and test
again.
Press [Exit] to main
menu.
Select Test
Battery Test
Grounding Test
Starter Test
Alternator Test
Then press [Enter]