Associated Equipment 12-1015 Quick Guide - Manual (Page 10)

10
PRINTER SETUP
1. The printer will only work when connected
directly to a 12Volt car battery because it
needs higher amps than an USB port from
the PC can provide. The red LED indicates
the printer is ON and the green LED will blink
when the printer has run out of paper. If
there is paper present and it still blinks then
the printer has overheating problem. The
green LED will also stay lighted up when
there is no paper if BST 12 is connected to
the PC through the USB port.
2. Open the printer cover (Fig. 5a). Place the
thermo paper roll into the slot with the paper
edge facing up (Fig. 5b). Make sure the
paper is about
¾
in out when the printer
cover is closed (Figure 5c).
SELECT DISPLAY LANGUAGE
1. To change the display language of the
Analyser, first go to Setup Menu by pressing
key until it has been highlighted and then
press key to enter.
Inside the Setup Menu press to gain access to the
Language Menu
Select the preferred language by pressing key to
scroll to the item.
Select Menu
New: Clear Memory
Continue Testing
View last Test
Setup Menu
Then press [Enter].
Setup Menu
Language
LCD Brightness
Printer
PC Link
[Enter] to proceed.
[Exit] to quit.
Select Language
English
Deutsch
Español
Italiano
[Enter] to save.
Figure 5a
Figure 5b
Figure 5c