Associated Equipment 12-1015 Quick Guide - Manual (Page 5)

5
19. Now you need to press key to proceed
and the display will show as follows
20. If the measured resistance reading is within
limits, then it will display as follows:
21. If the measured resistance reading has gone
beyond the limits, then it will display the
screen as follows:
Note:
The above indicates that the ground contact
from the engine body to the battery is bad.
Check for rusted or corroded point of contacts.
If found, dismantle it for cleaning or replace
before fixing back. Repeat the test again after
fixing.
22. If you did not follow the right procedures
during the testing, it will display the results
as follows:
23. To exit the program, pressing the key
at any moment will exit and return back to
main menu screen
Starter Test
Note: Before performing this test, make sure
that the battery is fully charged and in
good condition.
24. With engine OFF, place the vehicle
transmission in NEUTRAL for Manual and
PARK for Automatic then apply the parking
brake.
25. Pressing key once will scroll down to the
“Starter Test”
Analysing ...
Please wait!
Results: OK
The grounding
resistance of the
engine or car chassis
is within limit.
Results: High Ohms
The grounding
resistance of the engine
or car chassis is high.
Clean the cable
contacts or replace
cable if necessary.
Results: Not detected
Wrong procedures.
Try again and follow
the step by step
instructions given.
Select Test
Battery Test
Grounding Test
Starter Test
Alternator Test
Then press [Enter].