American Expedition Vehicles Moab/Call of Duty Rear Bumper Water Tanks with Pump Kit - Manual (Page 19)

Page 19 of 20
O. INSTALLING ACCESSORIES
1. AEV CHMSL – The AEV CHMSL can be added if using any AEV wheel. NOTE, the
AEV CHMSL will not work with all aftermarket wheels, please check with the wheel
manufacturer before purchasing. When installing the AEV CHMSL, reuse the factory
CHMSL wiring. CONNECT THE BLACK WIRE TO THE WHITE WIRE AND WHITE
WIRE TO THE BLACK WIRE.
2. PUMP KIT - Please see instructions in the Pump Kit box.
3. RECOVERY RACK - Please see instructions in the Recovery Rack box.
4. REAR BACK UP LAMP
– When installing the IPF Backup Lamp 8161, install per IPF
Instructions, use the L1 (white/gray) circuit located in C5 (Brown), Cavity 15 underneath
the TIPM for the rear backup lamp feed. Use the provided zip ties on Tire Carrier.
5. ANTENNA – CB or shortwave antennas can be mounted to the Tire Carrier and routed to
the front of the vehicle on the right side of the vehicle. Some setups may require an
additional ground strap for optimal performance. Use the provided zip ties on Tire
Carrier.