American Expedition Vehicles ProCal Module Quick Reference Guide User Manual

American Expedition Vehicles For the car

AXLE RATIO

OPTIONS

ENGINE FUNCTIONS

RUNTIME FUNCTIONS

VIN RELEASE

Set the last 6 based on preferred axle ratio using

the chart below.

Set the last 6 based on the chart below.

Set the last 6 using the chart below.

Set the first 3 DIP switches as shown.

Set switches as noted above & the last 4 based on the chart below.

one-touch lane change

daytime running lamps

auto sway bar system

Set the first 3 DIP switches as shown.

By design, the Daytime Running

Lamps will only function with the

E-Brake in the OFF position and the

vehicle in gear (auto trans only). To

verify the function is correct and

desired mode is set, pull the vehicle

up to a reflective surface or have a

by-stander verify function. Please

take caution to keep the vehicle

under control at all times

Programming axle ratio is only required after physically changing the gears in the

differentials. There is no performance increase by adjusting this value to anything

besides what the vehicle has physically installed. Programming the incorrect ratio

will cause some vehicles to go into “Limp-In” mode.

The functions SET PEDAL and SET VIN are for new installs of the AEV JK Hemi

Conversion vehicles only. Failure to correctly finish these functions could leave the

vehicle in a temporarily inoperable condition. If the vehicle currently runs, these

functions should not be executed.

This mode will restore all settings to their original values and

release the VIN locked in the Procal for use in another vehicle.

*The engine must be running with the E-brake engaged before inserting the Procal.

Use the dimmer switch to adjust idle set point.

Runtime functions do not program any values and require the Procal to remain

plugged in during their use.