Alpha Technologies PWE Battery Enclosure (BE) - Manual (Page 9)

1. Installation
9
033-077-C0-002 Rev. B
Overview
The PWE Battery Enclosure was designed to allow the customer to
add additional batteries in the field for additional standby/run time.
Upon receipt, the enclosure should be unpacked and inspected for
shipping damage. The following items should be enclosed:
1. Battery Enclosure (Alpha P/N 033-077-20)
2. Battery Cable ‘Y’ Adapter (Alpha P/N 874-655-20)
3. Battery Cable Kit (Alpha P/N 874-202-21)
4. Pole Mounting Bracket
5. Bracket Hole Drilling Template
6. New PWE Door
7. New PWE Lid
8. Rain Guards
9. Mounting Hardware
Tools and Materials Needed:
Digital Volt-Ohm Meter
Hand Operated Rivet Gun with .156” nosepiece
3/4” Drill Motor
3/4” Auger Bit (long enough to drill through pole)
7/16” Wrenches and Sockets
Torque Wrench
3 Batteries (manufacturer and type to match existing batteries)
1.1 BE Installation
NOTES: The total combined weight of a fully-populated PWE and BE is
approx. 600 pounds. Verify stability of the mounting pole before
installation.
Secure permission of pole owner for mounting of enclosure.
Obtain, review, and follow all appropriate electrical, building and
installation codes and practices of the local area and utilities.
Verify lifting equipment is safe and capable of weight requirements.
Verify area around, above and below is clear of all obstructions
which may pose a hazard during installation.
Post necessary hazard warnings for the work area.