Alpha Technologies CFR 5000, CFR 5000RM - Manual (Page 76)

5 Maintenance 70
Alpha Technologies
5.5 Configuring the Input/Output Voltage (Continued)
5.5.2: CFR 5000RM
Procedure:
Step 1: Reconfigure the Main Board
1 Turn off all loads. Make sure the Input and Battery circuit breakers on the rear panel
are switched off.
2 Remove the top panel.
3 Find the main board, labeled as 700–255–xx, on the top right hand side of the
interior when you are facing the rear panel.
4 Reconfigure the DIP switches and the jumpers according to the table printed on the
main board (see the diagram in Section 5.5.1, Step 1).
Main Board Reconfiguration Finished. Go to Step 2.
Rear P
anel
700-255-xx
Board