beautypg.com

5 configuring the input/output voltage (continued) – Alpha Technologies CFR 5000, CFR 5000RM User Manual

Page 75

background image

69

5 Maintenance

Alpha Technologies

5.5 Configuring the Input/Output Voltage (Continued)

Step 3: Reconfigure the Output Connectors

1

On the inside rear panel are four standoffs with the neutral and the 120/208/240

connectors as shown in the diagram below.

Ground

Stud

120 VAC

Neutral

208 VAC

240 VAC

2

Wire the output connector(s) to the output voltage you need.

3

Reattach the cover and the front panel.

4

Turn on the unit (Section 3.1). Before turning on the loads, measure the output

voltage to make sure this procedure has been done correctly.

Voltage Reconfiguration Finished

Input Terminal Block Reconfiguration Finished. Go to Step 3.