ABUS FUAA10021 Secvest IP Basic Set Quick operating instructions - Manual (Page 49)

47
Press The bottom LED lights in blue.
Press
You are now in programming mode and can
learn in the radio components. The 2nd LED from
the bottom lights up or flashes (lights = channel
is already occupied, flashes = channel is vacant).
2
To switch a channel further up, please press
The LED for the next channel will light up or
flash.
You can use the first three channels for learning
in the radio components. To learn in operating
units, select the respective channel and make the
unit transmit a certain radio signal, in accordance
with its learn in procedure.
Once the signal is received successfully, the
control panel will beep twice and the LED will
remain lit. If you want to learn in multiple operating units
(up to 3), select the respective channel and
repeat the previously described procedure.
If you now want to go on to learn in the detec-
tors, choose
LEDs 4-7 for the first detector group,
LEDs 8-10 for the second group and
LEDs 10-14 for the third group.
3
4 5
Learn in multiple operating units Learn in operating units
SELECT
SELECT
SET