ABUS FUAA10021 Secvest IP Basic Set Quick operating instructions - Manual (Page 40)

38
Status LED on the Secvest IP
Green LED (“Power” LED) for monitoring the power supply
• Permanently lit: power supply is OK
• Flashing with 1 Hz: mains power supply failure; is only indicated if
a backup battery is in use.
Red LED (“Trouble” LED) for indicating faults
• Off: no faults
• Flashing with 1 Hz: supervision fault (detector or device is indicated
by the channel LED flashing with 1 Hz. If only this LED flashes, this
indicates that the control panel itself has been tampered with).
• Permanently lit: indicates jamming.
Blue LEDs (“Channel” LEDs) for detector status display
• Off: detector OK (closed)
• Permanently lit: detector is open, or has triggered (open),
operating units are lit briefly signalising that a radio signal has
been sent.
• Flashing with 5 Hz: low battery
• Flashing with 1 Hz: tampering with detector or device
Bottom blue LED lights up: indicates that this refers to the second
caption level. (i.e. channels 8-14)