ABUS AZ4110 LCD Keypad for Terxon SX_MX Operating instructions - Manual (Page 38)

16
UK
9.8 Switching door chime on/off
Your alarm system can be programmed so that some
zones trigger a tone when entered. To activate/deactivate
the door chime for these zones:
Enter your user code.
The control unit shows:
Press
7 .
The control unit shows:
To toggle between on and off, press
7 again.
To confirm the setting, press
When the setting is saved, the alarm centre confirms with
a double tone and shows the date and time again.
9.9 System tests
9.9.1 Siren test
You can test all connected acoustic and visual signalling
devices. Proceed as follows:
Enter your user code.
The control unit shows:
Press
8 .
The control unit shows:
The alarm centre now tests in this order the outputs
marked as sirens, the outputs for the flashlight, the output
for the loudspeaker, and the control unit. At the end of the
test, the alarm centre emits with a double tone and shows
the date and time again.
9.9.2 Walk test
You can make a walk test to check that all sensors are
working properly. However, make sure that nobody else
can trigger a sensor during the test, since this would result
in a false test evaluation.
Enter your user code.
The control unit shows:
Press
9 .