Warning – Elmo Rietschle L-BV7 User Manual

Page 21

21 / 64

610.48060.40.000

Transport and Handling

Transport and handling by means of a crane
and strap belts is advisable.

Fig. 4: Attachment points

Attach the strap belts as shown in Fig. 4,
Pg. 21:

 Use two strap belts, of which one is routed

under the vacuum pump/compressor
housing, and one under the fan guard.

 The strap belts should be seated securely

in the undercuts so that the unit cannot slip
out.

 The belts must be sufficiently long (spread

angle smaller than 90°).

 Make sure that no damage is caused to any

attached fittings.

 WARNING

Danger from tipping loads!

Be sure to observe the routing of
the strap belts as shown in
Fig. 4, S. 21, even if the motor is
provided with attachment points
such as transport eyes or eye
bolts.

These are solely designed for the
separate transport of the motor,
however not for the different
weight distribution that results for
the mounted vacuum
pump/mounted compressor, so
that the unit could tip!