X145 e-display™ quick start instructions, X145 e-display default settings, Cla-val – Cla-Val X145 Quick Manual User Manual
Page 4: Time base (default = min), Total reset function (default = disabled), Bar graph (default = off), Low-flow cut-off (default = 5 gpm), Backlight (default = on), Typical application
X145 e-Display™
Quick Start Instructions
Decimal Point (Default = Decimal Point Not Displayed)
e-Display may be set with up to four decimal places or with no decimal point at all. Rate decimal and Total decimal
are programmed individually.
Units (Default Flow Rate = GPM, Default Total Flow = GAL)
e-Display can be set to show a combination of three alphanumeric characters for engineering units or for
identification.
Time Base (Default = MIN)
e-Display calculates total based on rate and a time base of units per second, minute, hour or day.
Total Reset Function (Default = Disabled)
e-Display is shipped from Factory with Total Reset Function disabled to avoid inadvertent total flow reset.
Bar Graph (Default = Off)
e-Display can be set to show a bar graph proportional to the percentage process reading within a user defined span.
Low-Flow Cut-Off (Default = 5 GPM)
The default Cut-Off is 5 GPM to prevent negative readings. This may be overridden to allow them.
Backlight (Default = On)
The Backlight is recommended for dim lighting conditions and is enabled from Factory. It may be bypassed by
modifying wiring: refer to page 12 of the provided e-Display™ Instruction Manual.
Refer to provided e-Display Instruction manual for more information regarding advanced programming.
4
CLA-VAL EUROPE
Chemin des Mésanges 1
CH-1032 Romanel/
Lausanne, Switzerland
Phone: 41-21-643-15-55
Fax: 41-21-643-15-50
E-mail: [email protected]
CLA-VAL FRANCE
Porte du Grand Lyon 1
ZAC du Champ du Périer
France - 01700 Neyron
Phone: 33-4-72-25-92-93
Fax: 33-4-72-25-04-17
E-mail: [email protected]
CLA-VAL
PO Box 1325 Newport Beach CA 92659-0325
800-942-6326
Fax: 949-548-5441
Web Site: cla-val.com
E-mail: [email protected]
©
COPYRIGHT CLA-VAL 2013 Printed in USA Specifications subject to change without notice.
CLA-VAL CANADA
4687 Christie Drive
Beamsville, Ontario
Canada L0R 1B4
Phone: 905-563-4963
Fax: 905-563-4040
E-mail [email protected]
CLA-VAL UK
Dainton House, Goods Station Road
Tunbridge Wells
Kent TN1 2 DH England
Phone: 44-1892-514-400
Fax: 44-1892-543-423
E-mail: [email protected]
N-X145 Quick Start Instructions
(R-03/2013)
X145 e-Display Default Settings
CLA-VAL
4-20mA
Signal
AC
Power
X144
e-FlowMeter™
X145
e-Display
Optional Output to
SCADA, PLC, logger, etc.
Typical Application