Cla-Val 90-01KO - Manual (Page 6)

Materials Pressure Ratings
(Recommended Maximum Pressure - psi)
Component Standard Material Combinations
Body & Cover Ductile Iron Cast Steel Bronze
100-01KO Available Sizes 1 1/4 " - 36" 3 " - 16" 3 " - 16"
Disc Retainer &
Diaphragm Washer
Cast Iron Cast Steel Bronze
Trim: Disc Guide,
Seat & Cover Bearing Bronze is Standard
Stainless Steel is Optional
Disc Buna-N ® Rubber
Diaphragm Nylon Reinforced Buna-N ® Rubber
Stem, Nut & Spring Stainless Steel
For material options not listed, consult factory.
Cla-Val manufactures valves in more than 50 different alloys.
Valve Body & Cover
Pressure Class
Flanged Grooved Threaded
Grade Material
ANSI
Standards*
150
Class
300
Class
300
Class
End‡
Details
ASTM A536 Ductile Iron B16.42 250 400 400 400
ASTM A216-WCB Cast Steel B16.5 285 400 400 400
ASTM B62 Bronze B16.24 225 400 400 400
Note: * ANSI standards are for flange dimensions only.
Flanged valves are available faced but not drilled.
‡ End Details machined to ANSI B2.1 specifications.
Valves for higher pressure are available; consult factory for details
Model 100-01KO
Specifications
Operating Temp. Range
Pattern Globe Angle Grooved End
Size 1 1/4 " - 36" 1 1/4 " - 16" & 24" 1 1/4 " - 8"
Fluids
-40° to 180° F APPROVED
(4" - 24")
SELECTION GUIDELINE FOR KO ANTI-CAVITATION VALVES
400
350
300
200
150
100
50
0
0 10 20 30 40 60 50 70 80
OUTLET PRESSURE (psi)
250
INLET
PRESSURE (psi)
Cavitation
Zone
90 100
Notes: On Operating Differential
1. For atmospheric discharge, the maximum inlet pressure cannot exceed 150 psi.
2. For pressure differentials greater than 300 psi, the maximum flow velocity should not exceed 18 ft/sec.
3. Flow velocities greater than 25 ft/sec are not recommended.
4. Recommended minimum flow velocity is 1 ft/sec.
5. Consult factory for conditions exceeding these recommendations.
100G-01KO ANTI-CAVITATION VALVE CURVES
100 10 1000 10000
FLOW RATE (gpm)
10
100
PRESSURE DROP
(psi)
400
1
300
SOLID LINE IS FULL OPEN FLOW CURVES FOR 18 FT/SEC CONTINUOUS DUTY APPLICATIONS
DASHED LINE IS FULL OPEN FLOW CURVE FOR 25 FT/SEC INTERMITTENT DUTY APPLICATIONS
100000
3"
4"
6"
8"
10"
12"
2" 2 1/2 "
1 1/2 "
16"
14"
20"
36"
30" 18"
1 1/4 "
24"
100-01KO (Main Valve)