Physio-Control LIFEPAK CR Plus - Manual (Page 22)

2-4 LIFEPAK CR Plus and LIFEPAK EXPRESS Defibrillator Operating Instructions
Getting Started
CONTROLS, INDICATORS, AND LABELS
This section introduces you to the controls, indicators, and labels on the LIFEPAK CR Plus and
LIFEPAK EXPRESS defibrillators.
Outside Controls, Indicators, and Labels
Controls, indicators, and labels on the outside of the defibrillator are identified in Figure 2-1 and
described in Table 2-1.
Figure 2-1 Outside Controls, Indicators, and Labels
Table 2-1 Outside Controls, Indicators, and Labels
Feature Description
Readiness Display There are four indicators that can appear when your defibrillator is turned off.
These indicators allow you to determine, just by looking at the defibrillator,
whether it’s ready for use or needs attention. They include the following:
The OK indicator appears when the defibrillator is turned off and
ready for use.
The CHARGE-PAK indicator appears when the CHARGE-PAK battery
charger needs to be replaced or is not installed in the defibrillator. If
needed, the defibrillator can be used in an emergency.
The attention indicator appears when the internal battery is not fully
charged. When this indicator first appears, the internal battery can
power the defibrillator for a minimum of 6 shocks or 42 minutes.
The wrench indicator appears when a condition prevents or could
prevent the defibrillator from operating normally.
Lid The top of the defibrillator.
ON-OFF button The ON-OFF button opens the defibrillator lid and turns the defibrillator on.
Pressing and holding the button for approximately 2 seconds after the lid is
open turns off the defibrillator.
Carrying
handle
Safety
warnings
Serial
number
label
Lid
CHARGE-PAK battery charger
Readiness
On-Off button
IrDA port
Use By
date display
OK