Extron Electronics RGB 400xi Series User Guide - Manual (Page 18)

RGB 460xi Series • Installation and Operation 2-10
Euro Channel and Floor Box Versions
The RGB 460xi and RGB 468xi are available in a Euro Channel
(EC) version, the RGB 460xi is available in two floor box models
(MK and FSR), and the RGB 468xi AKM UK is designed for
Ackermann floor boxes. (See appendix A for part numbers.)
The front and rear panel features, cabling requirements, and
testing/troubleshooting procedures are identical to the
descriptions shown in this chapter for the wall box models. For
installation instructions, see the RGB 400xi Series installation
guide that addresses your specific requirements.
Mounting Adapter Plates (AAPs/MAAPs)
All AAPs/MAAPs should be mounted before the interface is
tested or installed in a wall or furniture. Each AAP/MAAP has
standoffs (screws built into the rear panel) and nuts/hex screws,
which can be used to secure the AAP/MAAP to the interface.
1 . Insert the AAP/MAAP standoffs into screw holes in the
interface.
2. Using the #4-40 nuts (standard AAPs) or the 3/32" hex
screws (MAAPs) provided, secure the AAP/MAAP to the
interface.
Mounting an adapter plate (AAP shown)
3 . Repeat steps 1 and 2 to mount other AAPs/MAAPs. Cover
any openings in the interface with blank AAP/MAAP
plates.
#4-40 Nut w/ Captive
Washer
4-gang Wall Box
H. SH IFT
MI N/M AX
TM
RGB 468xi
Note: The RGB 468 Mxi (not
shown) uses hex screws
that mount the MAAPs
from the front, instead of
nuts, which mount the
AAPs from the rear (as
shown).
INPUT
MONITOR
AUDIO
RGB 468
W ITH A DS P
MO NI TO R
NO M ON ITO R