Extron Electronics RGB 400xi Series User Guide - Manual (Page 10)

RGB 460xi Series • Installation and Operation
Installation Overview
CAUTION Installation and service should be performed by
authorized personnel only. UL Listed electrical boxes are
recommended. See “UL requirements” in this chapter.
To install and set up an RGB 460xi Series interface, follow these
steps:
1 Turn off all equipment. Disconnect the computer, the
interface, and the output devices (e.g., projector/monitor,
speakers, etc.) from the power source.
2 If applicable, prepare the site as explained in the
appropriate installation guide.
3 Attach any optional architectural adapter plates (AAPs) to
the interface (RGB 468xi, RGB 468 Mxi, or RGB 468xi AKM
UK only) and then attach all the cables. See “Front Panel
Features and Cabling,” “Rear Panel Features and
Cabling,” and “Mounting Adapter Plates (AAPs/
MAAPs)” in this chapter.
4 Set rear panel DIP switches as explained in the “Rear
Panel Features and Cabling” section of this chapter.
5 Connect all output device, interface, and computer power
cords and then turn on all devices. All devices should
have power, and the audio and video should be working
properly. If not, check all cabling and switch settings, and
make adjustments as necessary.
6 Disconnect power from all the devices.
7 Mount the interface as explained in the appropriate
installation guide.
8 Restore power to the devices.
UL requirements
To comply with Underwriters Laboratories (UL) safety
requirements, the following minimum guidelines must be
followed:
• The interface must not be used beyond its rated voltage
range.
• The interface must be installed in UL Listed junction box.
• The interface must be installed with conduit in
accordance with the National Electrical Code.
2-2