Extron Electronics MTPX Plus Series Setup Guide - Manual (Page 23)

Refer also to the MTPX Plus User’s Manual at www.extron.com . Refer also to the MTPX Plus User’s Manual at www.extron.com .
Command
ASCII command (host to switcher)
Response (switcher to host)
Additional description
IP setup
Set IP
addr
ess
EX2^
CI
}
Ipi
X2^]
Read IP
addr
ess
E
CI
}
X2^]
Set subnet mask
EX2^
CS
}
Ips
X2^]
Read subnet mask
E
CS
}
X2^]
Set gateway IP
addr
ess
EX2^
CG
}
Ipg
X2^]
Read gateway IP
addr
ess
E
CG
}
X2^]
Set DHCP
on or of
f
EX2&
DH
}
Idh
X2&]
Read DHCP
on/of
f status
E
DH
}
X2&]
Set verbose mode
EX2*
CV
}
V
rb
X2*]
Read verbose mode
E
CV
}
X2*]
Configur
e curr
ent port timeout
E
0*
X2(
TC
}
Pti0*
X2(]
Read curr
ent port timeout
E
0TC
}
X2(]
Configur
e global IP
port timeout
E
1*
X2(
TC
}
Pti1*
X2(]
Read global IP
port timeout
E
1TC
}
X2(]
N
X2^
= IP
addr
ess
nnn
.nnn
.nnn
.nnn
X2&
= DHCP
0 =1 of
f, 1 = on
X2*
= V
erbose mode
0 = clear/none (default for T
elnet connection)
1 = verbose mode (default for RS-232/RS-422 connection) 2 = tagged r
esponses for queries
3 = verbose mode and tagged for queries
X2(
= Port timeout interval
1 (= 10 seconds) - 65000 (default is 30 = 300 seconds = 5 minutes)
Installing and Starting the Control Program
Another way to operate the switcher, to set the skew
adjustments, the level and peaking, and the output pre-peaking
(see "Optimizing the video", beginning on page 4-18), is via
the Windows ® -based Matrix Switchers Control Program.
This program is contained on the Extron Software Products
DVD (included with the switcher). Run this program on a
PC connected to a serial port ( i , j , and m on pages 2-5 and
2-6), Ethernet port ( k ), or USB port ( n ) on the switcher. The
program must be installed on a Windows-based computer and
cannot be run from the DVD.
N For details on operating the program, refer to the
MTPX Plus User's Manual, chapter 5, “Matrix
Software” .
Installing the program
N To run this program while your computer is connected
to an MTPX Plus 128 Configuration (USB) port, use
version 7.7 or newer of the Matrix Switchers Control
Program.
1 . Insert the DVD into the drive. The Extron software DVD
window should appear automatically.
N If the window does not self-open, run Launch.exe from the
DVD.
The Extron software DVD window appears.
2 . Click the Software tab.
3 . Scroll to the Matrix Switchers program and click
Install
.
MTPX Plus Series • Remote Control and Optimizing the Video
Remote Control and Optimizing the Video, cont’d
4-14 MTPX Plus Series • Remote Control and Optimizing the Video 4-15