Extron Electronics P-2 DA6xi User Guide - Manual (Page 5)

1
Description
The Extron P/2 DA4xi and P/2 DA6xi VGA-QXGA are high
performance distribution amplifiers featuring one input, four
outputs and one input, six outputs, respectively. Both P/2 DA
units accept a VGA-QXGA video signal from a computer and
distribute the signal to individually buffered outputs and one
buffered loop-through. Each output is extendable up to 250'
(76 m) with Extron’s VGA cables.
Examples of typical installations are shown in the diagrams on
the following pages.
Features
•
Bandwidth — 350 MHz (-3dB) RGB video bandwidth, fully
loaded
•
Video Gain switch — Selectable video gain of 0.7 V or
1 V (when the input signal is 0.7 V p-p) to compensate for
long cable runs
•
Power LEDs — Located on both front and back panels
•
Versatile mounting options — A metal enclosure and a
wide variety of mounting options
•
ID bits pass through — Ensures the signal from the source
matches the resolution and refresh rate of the local monitor.
Installation
The P/2 DA4xi and P/2 DA6xi can be mounted on a rack shelf,
under a desk, or through a desk.
Rack mounting
UL guidelines for rack mounting
The following Underwriters Laboratories (UL) guidelines are
relevant to the safe installation of these products in a rack:
Elevated operating ambient temperature — 1. If the unit
is installed in a closed or multi-unit rack assembly, the
operating ambient temperature of the rack environment
may be greater than room ambient temperature. Therefore,
install the equipment in an environment compatible with
the maximum ambient temperature (Tma: +122 °F, +50 ° C)
specified by Extron.
Reduced air flow —
2. Install the equipment in the rack so that
the equipment gets adequate air flow for safe operation.
P/2 DA 4xi/6xi • User’s Guide