Extron Electronics P-2 DA6xi User Guide - Manual (Page 13)

P/2 DA4xi/6xi • User’s Guide
N These DAs are compatible with all the signal formats listed
above when the gain DIP switch is set to 0.7 V. They are
compatible with only RGBHV and RGBS when the gain DIP
switch is set to 1.0 V.
Connectors
P/2 DA4xi .......................... (4) 15-pin HD female
P/2 DA6xi .......................... (6) 15-pin HD female
Nominal level ................................ 1.0 Vp-p for Y of component video and
S-video, and for composite video
0.7 Vp-p for RGB and for R-Y and B-Y of
component video
0.3 Vp-p for C of S-video
Minimum/maximum levels ........ 0.3 V to 1.5 Vp-p (follows input)
Impedance ..................................... 75 ohms
Return loss ..................................... <-40 dB @ 5 MHz
DC offset ........................................ ±5 mV with input at 0 offset
Sync
Input type ...................................... RGBHV, RGBS, RGsB, RsGsBs; bi-level
and tri-level sync
Output type .................................... RGBHV, RGBS, RGsB, RsGsBs; bi-level
and tri-level sync (follows input)
N These DAs are compatible with all the signal formats listed
above when the gain DIP switch is set to 0.7 V.
Input level ..................................... 1.8 V to 5.0 Vp-p
Output level .................................. TTL: 5.0 Vp-p, unterminated
Input impedance .......................... 510 ohms
Output impedance ....................... 50 ohms
Max. propagation delay ............... 60 ns
Max. rise/fall time ........................ 2 ns
Polarity............................................ Positive or negative (follows input)
9