Extron Electronics P-2 DA6xi User Guide - Manual (Page 12)

P/2 DA4xi/6xi • User’s Guide
P/2 DA4xi and P/2 DA6xi, cont’d
Specifications
Video
Gain ................................................ 0 dB or +3 dB (when input is 0.7 Vp-p,
output is 0.7 V or 1.0 V, switchable)
Bandwidth ..................................... 350 MHz (-3 dB), fully loaded
Video input
Number/signal type ..................... 1 VGA-QXGA RGBHV, RGBS, RGsB,
RsGsBs, HDTV component video, S-video,
composite video
N These DAs are compatible with all the signal formats listed
above when the gain DIP switch is set to 0.7 V. They are
compatible with only RGBHV and RGBS when the gain DIP
switch is set to 1.0 V.
Connectors .................................... (1) 15-pin HD female (optional Mac/VGA
adapters are available)
Nominal level ................................ 1.0 Vp-p for Y of component video and
S-video, and for composite video
0.7 Vp-p for RGB and for R-Y and B-Y of
component video
0.3 Vp-p for C of S-video
Minimum/maximum levels ........ Analog: 0.3 V to 1.5 Vp-p with no offset at
unity gain
Impedance ..................................... 75 ohms
Horizontal frequency .................... 15 kHz to 135 kHz
Vertical frequency .......................... 30 Hz to 150 Hz
Return loss ..................................... <-40 dB @ 5 MHz
Input coupling ............................... DC
Video output
Number/signal type
P/2 DA4xi .......................... 4 VGA-QXGA RGBHV, RGBS, RGsB,
RsGsBs, HDTV component video, S-video,
composite video (follows input type)
P/2 DA6xi .......................... 6 VGA-QXGA RGBHV, RGBS, RGsB,
RsGsBs, HDTV component video, S-video,
composite video (follows input type)
8