Extron Electronics MLM 206 7GWP - Manual (Page 2)

MediaLink ™ Mounting Options Installation Guide, cont’d
MediaLink ™ Mounting Options • Installation Guide 2
2. Lift the faceplate off the MLC 206.
Remove four screws.
Faceplate
Extr
on
Med
iaLink DISPLA
Y
PO WER
VO LUME
MAX
MIN
Plastic Window
3. Align the openings in the new MLM faceplate with the controller’s buttons,
knob, and LEDs, and place the new faceplate on the MLC, as shown above.
4. Replace the four screws removed in step one, and hand tighten them.
5. Install the MLC 206 MediaLink controller in a wall or furniture as
appropriate. If necessary, use one of the cutout templates in this guide to
create an opening in the installation surface of a lectern or other furniture.
Templates
Use the appropriate template on the next 2 pages as a guide to measure and mark
the hole in the wall or furniture for installing the faceplate with an MLC 206.
The templates are not to scale and are provided for reference only.
The controller requires a depth of at least 1.5" (3.8 cm) inside the wall or furniture.