Extron Electronics ISS 506 IO_board Installation - Manual (Page 4)

Installation
ISS 506 Optional I/O board • Installation
The ISS 506 can be modified to install or remove optional boards that change the input and/or output formats that
the switcher can process. The following optional I/O boards are available:
•
SDI/HD-SDI input
• Scan converter (low resolution) output
• HD-SDI output
•
DVI output
Modify the ISS by performing the procedures in the following sections, as applicable:
1 Opening the Switcher
2 Installing an Optional SDI/HD-SDI Input Board
3 Installing an Optional Output Board
4
Closing the Switcher
Opening the Switcher
N Extron recommends that you send the unit in to Extron for service and updates.
To replace or install an optional input or output board, you will need to open the ISS’s case. Open the switcher as
follows:
1
. Disconnect the AC power cord from the ISS to remove power from the unit.
W To prevent electric shock, always unplug the ISS from the AC power source before opening the enclosure.
2 . If the ISS is installed in a rack, disconnect all signal and control cables and remove the ISS from the rack.