Extron Electronics ISS 506 IO_board Installation - Manual (Page 17)

Installation, cont’d
ISS 506 Optional I/O board • Installation
8 . Secure the output board to the back panel with the two screws ( i ) removed in step 2 (figure 12).
RS232/422
RESET
LAN
LO-
RES
OUT
R-Y/
R
C
Y/
G
VID
B-Y/
B
Y
9 9
Figure 12 — Secure the output board to the rear panel
9 . Close and reinstall the switcher. See “Closing the Switcher”, below.
Closing the Switcher
1 . Reconnect the fan power cord to connector J46 on the main board.
2 . Replace the top cover on the ISS.
3 . Fasten it with the screws that were removed in “Opening the Switcher“, on page 1, step 3.
4 . Rack mount the switcher, if desired, and reconnect all cables.