Extron Electronics ISS 506 IO_board Installation - Manual (Page 15)

Installation, cont’d
ISS 506 Optional I/O board • Installation
6 . See figure 10. Continue to apply presure until the connector extension(s) are fully mated with the main
board ( g ). Mated connectors are straight on the top and bottom of the connector extension.
7
7
Figure 10 — Output board installation
N Ensure that each contact on the connector extension(s) is properly mated with the output board, and not shifted to
the front or rear. If the board’s rear panel is not flush with the ISS’s rear panel, the board is probably not properly
mated.
7 . See figure 11. Secure the output board to the standoff on the main board with the included screw ( h ).