Extron Electronics MTP 15HD A Series User Guide Rev. F - Manual (Page 14)

Receiver Rear Panel Features
Figure 6 shows an MTP RL 15HD A receiver, which has all of the connectors and other
features that are on either receiver in the MTP 15HD A series.
INPUT
BUFFERED
OUTPUT
OUTPUT
POWER
12V
.5A MAX
MTP RL 15HD A
ON
1 2 3 4 5 6
H SYNC + V SYNC + C SYNC SOG VIDEO END UNIT
L
MONO AUDIO
R
NOTE A “C7” label is affixed to
receivers designed for
DTP 26 or CAT 7 cable.
NOTE: A “C7” label is affixed to
receivers designed for
STP201 or CAT 7 cable.
5
1 2 3 4
6
Figure 6. Receiver Rear Panel
a
Power connector — Plug the included external 12 VDC power supply into this 2-pole
captive screw connector.
CAUTION: Read the notes, cautions, and warnings in the " Power Supply
Wiring " section on page 13 before wiring the connector.
b
Input connector — Connect one end of the TP cable from the transmitter or from the
buffered output connector of an RL receiver to this RJ-45 female connector.
c
Buffered output connector — Connect one end of a TP cable to this female RJ-45
connector. Connect the free end of the same TP cable from the receiver to the Input
RJ-45 female connector on another receiver. See "
Twisted Pair Cable Termination " on
page 14 to wire the RJ-45 connectors.
CAUTION: Do not connect these devices to a computer data or
telecommunications network.
NOTES: • The non-C7 transmitters and receivers will not work properly with
STP201 or CAT 7 STP cable.
• The C7 transmitters and receivers will work properly only with STP201
or CAT 7 STP cable.
d
Output video connector — Connect a projector or other high resolution video device
to this 15-pin HD connector.
MTP 15HD A Series • Installation and Operation 10