Extron Electronics MTP 15HD A Series User Guide Rev. F - Manual (Page 13)

d
Audio input connector — Plug a 3.5 mm stereo audio plug into this connector for
unbalanced audio input. Wire the plug as shown in figure 5. The stereo audio input is
summed and output on the TP cable as mono audio.
Sleeve ( )
Ring
Right (-)
Tip
Left (+)
Figure 5. 3.5 mm Stereo Audio Plug
e
Pre-Peak switch — The Pre-Peak switch alters the TP signal output to correct for
long cable runs. See the table on page 4 for suggested switch settings based on the
transmitted video format and transmission distance.
f
Output connector — Connect one end of a TP cable to this RJ-45 female connector
on the transmitter. Connect the free end of the same TP cable to the RJ-45 female
connector on the receiver. See "
Twisted Pair Cable Termination " on page 14 to wire
the RJ-45 connectors.
CAUTION: Do not connect these devices to a computer data or
telecommunications network.
NOTES: • The non-C7 transmitters and receivers will not work properly with
STP201 or CAT 7 STP cable.
• The C7 transmitters and receivers will work properly only with STP201
or CAT 7 STP cable.
MTP 15HD A Series • Installation and Operation 9