Extron Electronics MTP 15HD A Series User Guide Rev. F - Manual (Page 12)

Transmitter Rear Panel Features
Figure 3 shows an MTP T 15HD A transmitter, which has all of the connectors and other
features that are on either transmitter in the MTP 15HD A series.
OUTPUT INPUT
AUDIO
POWER
12V
.5A MAX
MONITOR
PRE-PEAK
ON
OFF
MTP T 15HD A NOTE: A “C7” label is affixed to
transmitters designed for
STP201 or CAT 7 cable.
4
1 2 3 5 6
Figure 3. Transmitter Rear Panel
a
Power connector — Plug the included external 12 VDC power supply into this 2-pole
captive screw connector.
CAUTION: Read the notes, cautions, and warnings in the " Power Supply
Wiring " section on page 13 before wiring the connector.
b
Input video connector — Connect a computer video source to this 15-pin HD
connector for high resolution video input (see figure 4).
5 1
15 11
6 10
Female
Figure 4. 15-pin HD Connector
NOTES: • Input only sync signals (no video signals) on the sync pins (13 and 14).
• For component video, use the R (R-Y) and R return pins (pins 1 and 6),
G (Y) and G return pins (pins 2 and 7), and B (B-Y) and B return pins
(pins 3 and 8). For S-video, use the R, R return (C-chroma), G, and
G return (Y-luma) pins.
• For composite video, use the G pin and the associated return pin. For
additional genlocked video signals, use the R, B, and associated return
pins.
c
Monitor connector — Connect a video monitor to this 15-pin HD connector for
buffered, high resolution video loop-through.
MTP 15HD A Series • Installation and Operation 8