beautypg.com

Extron Electronics MTP 15HD RS Series User Guide Rev. F User Manual

Page 21

background image

Maximum resolution ..................... Up to 1920x1200 or 2048x1080 or 1080p at 300'

Up to 1024x768 at 600'

NOTE:

Refer to the user guide for the maximum distances recommended for specific resolutions.

Sync

Input type (transmitters) ................ RGBHV, RGBS, RGsB, RsGsBs
Output type (receivers) .................. RGBHV, RGBS, RGsB, RsGsBs
Standards ..................................... NTSC 3.58, NTSC 4.43, PAL, SECAM
Input level (transmitters) ................ 3.5 V to 5.5 Vp-p, unterminated
Output level (receivers) .................. 4.0 V to 5.0 Vp-p, unterminated
C7 models

Input impedance ....................... 573 ohms
Output impedance .................... 92 ohms ±8% (25 mA)

All other models

Input impedance ....................... 510 ohms
Output impedance .................... 110 ohms

Max. input voltage ........................ 5.5 Vp-p
Polarity

Transmitter ................................ Positive or negative (follows input polarity)
Receivers ................................... Positive or negative (switch selectable)

Control/remote — external device (pass-through, unidirectional or bidirectional)

Serial control port input/output

MTP C7 T 15HD RS, MTP T 15HD RS

RS-232 via (1) 3.5 mm, 3 pole captive screw connector

Receivers ................................... 1 set of proprietary signals on a female RJ-45 jack

Serial control port output/input

MTP C7 T 15HD RS, MTP T 15HD RS

1 set of proprietary signals on a female RJ-45 jack

Receivers ................................... RS-232 via a 3.5 mm, 3 pole captive screw connector

Baud rates .................................... Up to 38400 bps at up to 600' (183 m) (Higher data rates and distances are

possible. Performance varies based on baud rate and cable length.)

Protocol ........................................ Data bits = 5 - 8

Stop bits = 1 or 2
Parity = odd, even, none
Flow control = XON, XOFF, none

NOTE:

Protocol is mirrored between the transmitter and the receiver.

Serial control pin configuration ..... Captive screw connectors: 1 = TX, 2 = RX, 3 = GND

General

Recommended cable type

C7 models ................................. Extron STP201 or CAT 7
All other models ........................ CAT 5/5e/6 (shielded or unshielded)

Power supply ................................ External

Input: 100-240 VAC, 50-60 Hz
Output: 12 VDC, 1 A, 12 watts

Power input requirements ............. 12 VDC, 0.5 A
Temperature/humidity ................... Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing

Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensing

Cooling ......................................... Convection, no vents

MTP 15HD RS Series • Reference Information

17