Extron Electronics MTP 15HD RS Series User Guide Rev. F - Manual (Page 12)

d
Select button (SEQ model only) — This recessed button selects the Red, Green, or
Blue video signal to adjust and resets all three video signals to a skew delay of zero
nanoseconds.
Use a small screwdriver to press and release this button to cycle among selecting the
Red, Green, or Blue video signal to adjust. The selected signal is indicated by the Red,
Green, and Blue LEDs (
e
).
NOTE: The SEQ receiver automatically saves the setting for the video signal that is
being deselected when you push this button or when the selection times out
after 10 seconds.
Press and hold this button for approximately 3 seconds to set the skew delay for Red,
Green, and Blue to zero. The Red, Green, and Blue LEDs (
e
) all turn off. Release the
button.
e
Red, Green, and Blue LEDs (SEQ model only) — These LEDs indicate the video
signal that is selected by the Select button (
d
) for skew adjustment using the
Delay control (
f
). The LED of the selected color flashes when skew compensation for
the selected video signal has reached the minimum or maximum limit.
f
Delay (skew adjustment) control (SEQ model only) — This control delays the
selected Red, Green, or Blue video signal by up to 62 nanoseconds. The delay is applied
in incremental, 2-nanosecond steps. Rotate the control counterclockwise to reduce the
delay or clockwise to increase the delay.
NOTES: • The control turns smoothly; it does not have mechanical steps or
high and low limit stops.
• Watch the displayed image to observe the steps of delay.
• The selected Red, Green, or Blue LED (
e
) flashes to indicate that
the control has reached the minimum (counterclockwise rotation) or
maximum (clockwise rotation) limit.
• For additional information on skew adjustment, see the " Skew Delay
Compensation " section on page 15.
MTP 15HD RS Series • Installation and Operation 8