Extron Electronics MTP 15HD RS Series User Guide Rev. F - Manual (Page 15)

Receiver Rear Panel Features
Figure 7 shows an MTP RL 15HD RS receiver, which has all of the connectors and other
features that are on either receiver in the MTP 15HD RS series.
INPUT
BUFFERED
OUTPUT
POWER
12V
.5A MAX
MTP RL 15HD RS
ON
1 2 3 4 5 6
H SYNC + V SYNC + C SYNC SOG VIDEO END UNIT
OUTPUT
Tx Rx
RS-232
NOTE A “C7” label is affixed to
receivers designed for
DTP26 or CAT 7 cable.
NOTE: A “C7” label is affixed to
receivers designed for
STP201 or CAT 7 cable.
5
1 2 3 4
6
Figure 7. Receiver Rear Panel
a
Power connector — Plug the included external 12 VDC power supply into this 2-pole
captive screw connector. Wire the connector as shown in figure 9 on page 13.
CAUTION: Read the notes, cautions, and warnings in the " Power Supply
Wiring " section on page 13 before wiring the connector.
b
Input connector — Connect one end of the TP cable from the transmitter or from the
buffered output connector of an RL receiver to this RJ-45 female connector.
c
Buffered output connector — Connect one end of a TP cable to this female RJ-45
connector. Connect the free end of the same TP cable from the receiver to the Input
RJ-45 female connector on another receiver. See "
Twisted Pair Cable Termination " on
page 14 to wire the RJ-45 connectors.
CAUTION: Do not connect these devices to a computer data or
telecommunications network.
NOTES: • The non-C7 transmitters and receivers will not work properly with
STP201 or CAT 7 STP cable.
• The C7 transmitters and receivers will work properly only with STP201
or CAT 7 STP cable.
d
Output video connector — Connect a projector or other high resolution video device
to this 15-pin HD connector.
e
RS-232 connector — Connect a serial communications port to this 3.5 mm, 3-pole
captive screw connector for bidirectional RS-232 communication. Wire the connector as
shown in
figure 6 on page 10.
NOTE: Read the RS-232 connector notes on page 10 before wiring the connector.
MTP 15HD RS Series • Installation and Operation 11