Extron Electronics MLM-UDSM - Manual (Page 4)

MLM-UDSM Installation Guide, cont’d
MLM-UDSM • Installation Guide
Install the MLC and AAP accessories in the sliding enclosure
1. Set the sliding enclosure’s top plate on the table/desk.
2. If applicable, set the DIP switches on any AAP devices to be attached to the
MLM-UDSM.
3. Attach AAP plates or AAP devices: insert the
AAP plate’s or device’s screws through
the holes in the MLM-UDSM’s AAP
mounting area, as shown at
right. Secure the AAP plate
or device to the
MLM-UDSM
with the captive
washers and
#4-40 nuts that
came with the AAP
plate or device.
4. Connect cables to
the AAP plates’
and/or devices’ rear
connectors.
5. Remove the MLC 206’s original faceplate. Use a small Philips screwdriver to
remove the four faceplate attachment screws marked
a
in the figure below,
and save them
for later use.
N Do not remove these screws
while the MLC is installed
in a wall or furniture, or the
controller may fall down into the
wall/furniture or wall box.
6. Lift the faceplate off the MLC as
shown below.
Plastic Window
Faceplate
Remove four screws
Ext
ron
Me dia Lin k C on tro ller ML C 2 06
DIS PL AY
PO WE R
VO LU ME
MA X/
MIN
Ext
ron
ML M-U DS M
DIS PL AY
PO WE R
VO LU ME
MA X/
MIN
DV D C ON TR OL
REW
PLA Y
NEXT
PA US E ST OP Tx
Adapter Plate
MLM-UDSM
Top Plate
Extron
MediaLink Controller
MLC 206
DISPLAY POWER
VOLUME
MAX/
MIN
VCR DVD Laptop
1
1
1
1