Extron Electronics IN1502 User Guide - Manual (Page 5)

QS-1 IN1502 • Quick Start
Quick Start — IN1502
Installation
Step 1
See the application example below. Turn off power
to the scaler and input and output devices, and re-
move power cords from them.
Step 2
Install the four rubber feet on the bottom of the
IN1502 scaler, or mount the scaler in a rack.
Step 3
Attach input devices to the scaler.
Rear panel video inputs
Input 1: Composite video
Input 2: S-video
Step 4
Attach an output device to the scaler.
Rear panel video output
Output 15-pin HD connector
Step 5
Plug the IN1502 and input and output devices into a
grounded AC source, and turn on the input and
output devices.
Step 6
Use the LCD menu screens or RS-232 programming
to configure the scaler. See chapter 2
for installation and operation
procedures, and see chapter 3 for
programming information.
RS-232 Control
LCD Projector
DVD
VCR
IN1502
Video Scaler
2 3 CO MP OS ITE VI DE O
RE MO TE
RG B
I
N
P
U
T
S
O
U
T
Application example
1 2
S-VIDEO COMPOSITE I
N
P
U
T
S
RGB
O
U
T
REMOTE
Main menus
MENU
PICTURE
CONTROL
MENU
OUTPUT
CONFIG
MENU
ADVANCED
CONFIG
MENU
NEXT
MENU
EXIT
MENU
Power
on
INPUT 1
CMPOSITE
INPUT 1
CMPOSITE
2 sec.
60-726-1
FW v.1.00
1360 x
765 @60
EXTRON
IN1502 2 sec.
2 sec.
2 sec.
2 sec.
DEFAULT CYCLE
2 sec.
NO
SIGNAL
2 sec.
The No Signal default
menu only occurs if
there is no signal
present at the currently
selected input. NOTE
Output rates
Scaler Output Resolutions and Rates
Resolution
50 Hz 60 Hz
640 x 480 X X
800 x 600 X X
848 x 480 X X
852 x 480 X X
1024 x 768 X X*
1280 x 768 X X
1360 x 765 X X
1366 x 768 X X
* The default resolution and rate is 1024 x 768 @ 60Hz.