Extron Electronics HDMI DA6 User Guide - Manual (Page 9)

Installation
This section of the guide describes the following topics concerned with the installation and
setup of the HDMI DA4 and HDMI DA6 distribution amplifiers.
z
Installation Overview
z Rear Panel Features
z Connecting Power
z Connecting the Input Source
z Connecting Output Displays
z
Wiring for RS-232 Control
z Connecting to the USB Port
Installation Overview
To install and set up the HDMI DA4 or HDMI DA6, follow these instructions:
1. Mount the Distribution Amplifier in a suitable location (see page 14).
2. Connect to a 100-240 VAC (50 or 60 Hz) power source using the provided IEC power
cord (see page 4).
3. Connect the display devices and power them on (see page 5).
The distribution amplifier automatically reads and stores EDID from the selected display
device. By default, this is the device connected to output 1. For other EDID options, see
EDID Minder on page 11.
4. If configuration using SIS commands is required (see page 15), connect a control PC
to the rear panel captive screw connector (see page 6) or the front panel USB port
(see page 7).
5. Connect and power on the input device (see page 5).
HDMI DA4 and HDMI DA6 • Installation 3