Extron Electronics HDMI DA6 User Guide - Manual (Page 29)

HDMI DA4 and HDMI DA6 • Updating Firmware 23
In the Add Device dialog box, the path to the new firmware file is displayed in the Path
field.
Figure 12. Path to the New Firmware File on the Add Device Window
10. If this is the only device to which you are uploading firmware, click Add. The
distribution amplifier information is added to the Devices section of the Firmware Loader
dialog box and the Add Device dialog box closes.
If you will be uploading the firmware to multiple units that are connected to your
computer, do the following:
a. Click Add Next. Your first device is added to the Devices section of Firmware Loader
dialog box, and the Add Device dialog box remains open.
b. For each additional device you want to add to the Firmware Loader dialog box, repeat
steps 5 through 9, then click Add Next.
c. For the last device, click Add (instead of Add Next) to add the device and to close
the Add Device dialog box.