Extron Electronics FPC 5000 - Manual (Page 18)

FPC Installation and Operation, cont’d
FPC 5000 Front Panel Controller • FPC Installation and Operation 2-10
Upgrading the Software
The Front Panel Controller software is factory installed on the FPC computer’s hard
drive and it is also included on a CD-ROM. Extron sends any needed software
upgrades on a CD-ROM.
Upgrade the FPC software as follows:
1 . If necessary, log the FPC 5000 on to the Matrix 12800 system as an
administrator. See Starting Up the Controller and Logging In and Out in
chapter 3, Matrix 12800 Operation.
2 . On the front panel LCD, touch the blue Admin button.
3 . On the front panel LCD, touch the purple Misc button.
4 . On the front panel LCD, touch the gray Re-Install FPC Software button. The
FPC prompts you to insert the CD-ROM containing the FPC software into the
CD tray. To exit without installing the software, touch on the gray Cancel
button.
5 . On the rear of the FPC, press the eject button on the CD-ROM drive
(figure 2-11). The drive’s LED flashes and the CD tray partially ejects.
On the rear of the FPC, gently pull the CD tray to its fully extended position.
PRN
DIO
C
EXT
. FDD
MOUSE
K/B
NET
CD Eject
Button
Figure 2-11 — Eject button location