Extron Electronics FOX DA8 Plus User Guide - Manual (Page 19)

Using the Program
NOTE: The first time you connect to the Configuration (USB) port, the Found New
Hardware Wizard appears (see figure 8, below). See “ Activating a USB port
for the first time ,“ below.
For other connections, proceed to “Starting the program,” on the next page.
1
1
2
2
Figure 8. Found New Hardware Wizard
Activating a USB port for the first time
The first time you connect to the Configuration (USB) port, the Found New Hardware Wizard
appears (figure 8). Activate the connected USB port for your device as follows:
NOTE: If you have not installed the latest FOX Extenders Control Program (version 1.5
or newer), click Cancel , install the program, and reboot the PC. Reconnect the
computer to the Configuration port on the DA.
1. Select the No, not this time radio button and click Next .
2. Select the Install the software automatically radio button and click Next .
Follow the on-screen instructions. The wizard assigns the driver necessary to access the
DA to the connected Configuration (USB) port (this may take a few minutes).
3. Click Finish to exit the wizard.
4. Proceed to “ Starting the program ” on the next page or return to the “ Simple
Instruction Set Control ” section.
NOTE: You may need to repeat these steps if you subsequently connect the DA to
a different USB port on the same computer.
FOX DA8 Plus • Remote Control 13